setup_guide
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
setup_guide [2017/01/11 15:50] – darky83 | setup_guide [2019/12/03 02:15] (current) – [Source Build install] spammy | ||
---|---|---|---|
Line 7: | Line 7: | ||
==== System Requirements ==== | ==== System Requirements ==== | ||
- | Minimum system requirements are 2 vCPUs, 8GB of memory, and 100GB of disk space (as of version | + | Minimum system requirements are 2 vCPUs, 8GB of memory, and 100GB of disk space (as of version |
However, these are just minimum requirements. | However, these are just minimum requirements. | ||
Line 15: | Line 15: | ||
===== Deploying ===== | ===== Deploying ===== | ||
- | There are currently 3 options to deploy eFa, deploying on of the VM image is the most common way to start with eFa. | ||
- | If you don't have the option to deploy an Virtual Image (on some VPS hosters for example) you can build eFa using the build scripts. | + | https:// |
- | + | ||
- | - Visit https:// | + | |
- | - Import the appliance into your hypervisor. | + | |
- | - [[Deploying on VMware]] | + | |
- | - [[Deploying on Hyper-V]] | + | |
- | - Power on the virtual machine | + | |
- | - Follow the console prompts to configure your eFa. | + | |
- | - After you configure eFa and it reboots, it is recommended that you run an update. | + | |
- | - sudo / | + | |
===== Source Build install ===== | ===== Source Build install ===== | ||
- | | + | |
- | * [[Deploying E.F.A. on clean CentOS installation]] | + | |
===== Post-installation ===== | ===== Post-installation ===== | ||
* [[Initial Configuration]] | * [[Initial Configuration]] | ||
* [[Post Configuration]] | * [[Post Configuration]] | ||
* [[Adding mail domains]] | * [[Adding mail domains]] |
setup_guide.1484149815.txt.gz · Last modified: 2017/01/11 15:50 by darky83